BannerFans.com
Showing posts with label car will not crank. Show all posts
Showing posts with label car will not crank. Show all posts

Friday, November 11, 2011

How to remove Combination Switch on 2005 BMW 325?

The procedure is as follows :---


Combination Switch


Removal & Installation





Click image to see an enlarged view
Fig. Remove lower section of the steering column casing by unscrewing the fasteners


Click image to see an enlarged view
Fig. Remove upper section of steering column casing after unclipping the catches

CAUTION
On vehicles equipped with an air bag, the negative battery cable must be disconnected, before working on the system. Failure to do so may result in deployment of the air bag and possible personal injury.

  1. Disconnect the negative battery cable. Remove the steering wheel.
  2. Remove the lower instrument panel on the left side.
  3. Remove the steering column casing lower section.
  4. If equipped with an air bag, drive out the pins and lift out the expansion rivet. Remove the upper section of the steering column casing.
  5. Remove the plug and disconnect the electrical connectors.
  6. Push in the retaining hooks on both sides and pull out the switch.
To install:
  1. Press the switch in position until the retaining hooks engage it in place.
  2. Attach all electrical connectors and install the plug.
  3. The remaining components are installed in the reverse order from which they were removed.
  4. Install the steering wheel and connect the negative battery cable.

-----------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

The Brake Indicator Light Stays On dash of car?

The ABS and Traction Control Lights stays ON dash of car?


Check Engine Light On car?

 -------------------------

How to replace Interior Lights on car?

Car lights not working, even after replacing the bulb/lamp?

Click this link below:--
 ---------------

How to replace head lights on car?

--------------------

How to replace Parking, turn, and Brake Lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-parking-turn-and-brake.html

How to remove Speakers on 2005 BMW 325?

The instructions with diagrams is as follows :---


Speakers



Removal & Installation



Door/Dash Mounted Speakers/Tweeters
E30 Models
  1. Remove the grilles by removing the screws, if equipped, or pulling up and prying out.
  2. Remove the speaker mounting screws and the speakers. Disconnect the wires.
  3. Connect the wires and install the speakers in the cutouts. Install the screws and grilles.
E36 Models
  1. Remove the door panel as outlined in Section 10.
  2. Disconnect the speaker's electrical connector by squeezing in on the connector lock tabs and pulling the connector outward.
  3. Turn the speaker lock ring counter clockwise and remove the speaker.
  4. Installation is the reverse of the removal procedure.


Click image to see an enlarged view
Fig. A door panel mounted speaker as viewed from behind the door panel-1997 318i model shown
Front Kick Panel Speakers
  1. On left side speakers, remove the hood release lever on the left side.
  2. Remove the kick panel trim by turning the lock screws 90 °. Pull the panel out and to the rear to remove.
  3. Remove the screws and wires from the speakers and remove.
To install:
  1. Connect the wires and install the speakers in the cutouts. Install the screws and kick panels.
  2. If removed, install the hood release lever.
Rear Hat Shelf Speakers
  1. Remove the grilles by removing the screws, if equipped, or by carefully pulling up to release.
  2. On two or four door sedan models, remove the speaker mounting screws and the speakers. Disconnect the wires.
  3. On convertible models, pull the door handle release trim off and pull the speaker grille up and off.
To install:
  1. Connect the wires and install the speakers in the cutouts.
  2. Install the screws and grilles.

------------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------