BannerFans.com

Friday, November 11, 2011

How to remove Power Antenna on 2005 BMW 325?

The procedure is as follows :---

Power Antenna



Removal & Installation
  1. Turn the radio ON to extend the mast as far as it will go.
  2. Remove the nut at the base of the mast. Pull the mast out of the antenna assembly. A firm pull may be necessary.
To install:
  1. Install the new mast cable end into the opening and turn the radio OFF to draw the mast into the housing. Guide the mast and cable into the housing.
  2. Install the nut and operate the antenna several times to check the operation.
  1. Remove the trim panel at the antenna location. The rear light cover may need to be removed.
  2. Disconnect the antenna mounting bracket. Unplug the wiring.
  3. Loosen and remove the mounting nut at the body hole, if equipped. Pull the antenna out of the opening.
To install:
  1. Install the antenna and the mounting nut at the body hole.
  2. Install the mounting bracket and connect the wiring.
  3. Install the trim panel.


------------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

No comments:

Post a Comment