The procedure is as follows :---
S14 And M20 Engines
The car will not start?
Car will not crank?
Car has no spark?
How to troubleshoot car battery?
How to test starter solenoid?
http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html
--------------------
How to test cars starter?
http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html
How to replace starter in car?
car will turn over but will not start?
Car wont start?
Ignition Module
Removal & Installation
NOTE
The ignition module is incorporated into the DME control unit.
S14 And M20 Engines
- If possible, bring the engine to operating temperature prior to replacing the control unit.
- Turn the ignition switch OFF .
- Open the glove compartment and remove the pins from the straps so the door drops down.
- Remove the upper trim piece to access the DME unit.
- Push the plug retainer back and remove the plug. Remove the 4 bolts and remove the DME unit.
To install:
- Install the DME unit and the 4 bolts.
- Install the plug onto the DME unit and snap the retainer into place.
- Replace the trim and the glove compartment door.
Also if you need help for other ignition components replacing then go through:---
How to test and replace Ignition coil on 2005 BMW 325?
Important Ignition Components details For 2005 BMW 325?
For more car related problem troubleshooting:---
This are the sections, you can go through and click the link to read its troubleshooting.
---------
The car will not start?
-----------------
Car will not crank?
-----------
Car has no spark?
-------------
How to troubleshoot car battery?
-----------------
How to test starter solenoid?
http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html
--------------------
How to test cars starter?
http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html
How to replace starter in car?
-----------
car will turn over but will not start?
-----------------
Car wont start?
----------
No comments:
Post a Comment